GIVE US YOUR SUGGESTIONS & FEEDBACK ABOUT THE SITE
We will send you an E-mail every time there is a new article in your favorite section. Sign-Up For ALERTS.

Family Photo Projects

This project is about creating a lamp shade from your chosen photographs that you can hang over any room light bulb and have it illuminate your photographs and create a very special atmosphere.

For the lamp you need 6 identical vertical rectangles. The length of those rectangles will determine the height of your finished lamp. I would suggest to start with using photos the size of 4 x 5.5 so you can fit 2 images onto one sheet comfortably. If you want to use horizontal images make them fit the size of 8.5 by 11 and cut each one in half. Print your images on acetate (transparent film) or color photocopy them onto the same material in a copy shop. The photos you chose will affect the color of light that they will emanate and thereby affect the room atmosphere that your lamp will give (just bear this in mind, a lot of red and yellow colors in your photos will result in a warm light but dominant blue tones will result in a colder light.)         

For better visibility glue the transparencies to the tracing paper and then cut them out. Some bulbs are very bright and will be too intense for delicate images so the tracing paper (acting as another layer to diffuse the light), helps to bring out the colors in your photos. You can try the relevance of this effect on your particular image by holding your photos up to any room light with additional tracing paper behind them.

Make an equal amount of holes on both of the longer sides of all the 6 rectangles. There are several ways to do this. You can use a hole punch (but the holes are rather large and difficult to repeat exactly) or a hole punching device similar to scissors with adjustable sizes.

Use your string or thread to tie all the pieces together. Make sure the tracing paper is facing inwards. It looks nice to start at the bottom and have the two strings crossing over in a pattern. Cut the string generously because you should have about 6 inches left over when you reach the top.

To stabilize the edges and the overall shape of the lamp cut some very thin strips of cardboard (a quarter of an inch thick) and glue them to both the top and the bottom edge of the lamp.

Now you have a finished lamp shade. If you want you can decorate the corners with extra string. For one corner you cut about 10 pieces of string each about 3-4 inches in length and tie them around the string at the bottom of each corner.

^ Back to top

ohetothks666 http://ohetothks666.nu/ Posted by: ohetothks666 Nov 22, 2006 @ 4:1 AM EST

* Your Name:
* Email address:
	(Enter the code shown)
	(Your e-mail address will not show on the site and is used so that we can contact you back if needed)
* Your Comment about this article::
	Include me in the TGP Monthly Newsletter